[Loadstone] WAAS/EGNOS question
jim.noseworthy at compuconference.com
Fri May 28 23:23:45 BST 2010
Thanks for taking the time to respond to my post. I guess the reason I
asked was because there is a "unchanged" sellection. Anyway, thanks all
over the place.
----- Original Message -----
From: "Shawn Kirkpatrick" <shawn at loadstone-gps.com>
To: <loadstone at loadstone-gps.com>
Sent: Friday, May 28, 2010 6:54 PM
Subject: Re: [Loadstone] WAAS/EGNOS question
> There are a couple reasons for this default. Some receivers just don't
> support this (that's getting rarer these days). Also, in europe turning
> this on (egnos in this case) could sometimes produce less accurate
> results. The egnos system was in testing a few years ago so it didn't make
> sence to have this on by default. This situation may also have changed.
> You can just change this behaviour in settings if you want your receiver
> to use waas by default.
> On Fri, 28 May 2010, Jim Noseworthy wrote:
>> Hi Folks:
>> What would be the reason that Loadstone defaults to turning
>> WAAS/EGNOS off at startup?
>> Thanks all over the place gang.
> Loadstone mailing list
> Loadstone at loadstone-gps.com
> __________ Information from ESET NOD32 Antivirus, version of virus
> signature database 5154 (20100528) __________
> The message was checked by ESET NOD32 Antivirus.
__________ Information from ESET NOD32 Antivirus, version of virus signature database 5154 (20100528) __________
The message was checked by ESET NOD32 Antivirus.
More information about the Loadstone