[Loadstone] Sluggish signal; problem with database import

Geetha Shamanna geetha at millernorbert.de
Thu May 15 17:08:46 BST 2008


I switched on waas/egnos today, and it took half the time (about 90 seconds) 
for Loadstone to acquire signal. This is good. Thanks.

Geetha
----- Original Message ----- 
From: "Shawn Kirkpatrick" <shawn at loadstone-gps.com>
To: <loadstone at loadstone-gps.com>
Sent: Thursday, May 15, 2008 5:28 AM
Subject: Re: [Loadstone] Sluggish signal; problem with database import


> The no signal condition is your receiver, Loadstone can only work with the
> data it's getting.
> The import error just could be on line 123 of the file you're trying to
> import. There were probably more errors after that and the warnings made 
> it
> seem like a constant beep.
>
> On Wed, 14 May 2008, Geetha Shamanna wrote:
>
>> Hello all,
>>
>> Since installing version 0.70 on my 6600, I have encountered two 
>> problems:
>>
>> 1. Unlike with previous versions, it takes an unusually long time before
>> Loadstone gets the signal on a fresh start, sometimes as long as three
>> minutes. This occurs even when I am outdoors with the receiver. I 
>> Initially
>> attributed this to the receiver having low battery, but recharging it did
>> not help. This delay is quite consistent. Has anyone encountered this
>> problem?
>>
>> 2. On attempting to import a database, Loadstone displayed a message that
>> there was an error in line 123, and then produced a rather loud and
>> unceasing beep which continued until I restarted the phone. What could be
>> wrong?
>>
>> Many thanks.
>> Geetha
>>
>> _______________________________________________
>> Loadstone mailing list
>> Loadstone at loadstone-gps.com
>> http://www.loadstone-gps.com/mailman/listinfo/loadstone
>>
> _______________________________________________
> Loadstone mailing list
> Loadstone at loadstone-gps.com
> http://www.loadstone-gps.com/mailman/listinfo/loadstone
> 



More information about the Loadstone mailing list