[Loadstone] FW: GPS clock stops

Shawn Kirkpatrick shawn at odyssey.cm.nu
Fri Oct 12 10:17:16 BST 2007


Loadstone can also monitor cells and does by default. You could try turning 
the cell monitor in loadstone off and see if this helps.

On Fri, 12 Oct 2007, Sandberg, Robert wrote:

> Hi!
> I found out what causes the error I described below. I have a program
> called Mini GPS which I use to switch profiles when entering a specified
> cell. Each time it does that, Loadstone loses the connection and says
> "GPS clock seams to have stopped ticking". I don't get it, because Mini
> GPS is not actually a GPS program. It works solely by monitoring network
> cells. Is it possible to make Loadstone immune to this interference?
>
> Cheers,
> Robbie Sandberg
> -----Original Message-----
> From: Sandberg, Robert
> Sent: 11 October 2007 12:20
> To: 'loadstone at loadstone-gps.com'
> Subject: [Loadstone] GPS clock stops
>
> Hi!
> I often get the message: "GPS clock seams to have stopped." The
> connection then breaks off but the reciever is still switched on. I
> can't remember this happening before I upgraded to the current release.
> Can someone advise?
>
> Cheers,
> Robbie Sandberg
>
> _______________________________________________
> Loadstone mailing list
> Loadstone at loadstone-gps.com
> http://www.loadstone-gps.com/mailman/listinfo/loadstone
>


More information about the Loadstone mailing list