[Loadstone] No Signal and Signal Acquired transitions.

Shawn Kirkpatrick shawn at odyssey.cm.nu
Fri Aug 10 01:42:56 BST 2007


This could probably be done. Personally I've found with a good receiver the 
signal monitor just isn't needed since the receiver always seems to have a 
signal.

On Thu, 9 Aug 2007, Dave Mielke wrote:

> Could a setting be added so that one could be alerted to the "no signal" and
> "signal acquired" transitions just by short tone sequences with no
> announcements?
>
> -- 
> Dave Mielke           | 2213 Fox Crescent | I believe that the Bible is the
> Phone: 1-613-726-0014 | Ottawa, Ontario   | Word of God. Please contact me
> EMail: dave at mielke.cc | Canada  K2A 1H7   | if you're concerned about Hell.
> http://FamilyRadio.com/                   | http://Mielke.cc/bible/
> _______________________________________________
> Loadstone mailing list
> Loadstone at loadstone-gps.com
> http://www.loadstone-gps.com/mailman/listinfo/loadstone
>


More information about the Loadstone mailing list