[Loadstone] Understanding accuracy & Point Lists

Shawn Kirkpatrick shawn at odyssey.cm.nu
Sat Sep 2 07:23:25 BST 2006


The accuracy number is the gps accuracy in meters. This only what the 
receiver thinks it has, the results can vary. The lower the better.
To clear a route you can use the clear marked points option. If you're in 
route mode then just turn it off.

On Fri, 1 Sep 2006, Jeff Harrington wrote:

> When Load Stone tells you that you have an accuracy of say 1.0, .9 etc.
> What
> does this mean?  What is a good number?
>
> Also I understand how to create routes and load them, but how do you exit
> the route that you are in and go back to basic Navigation or Exploration
> Mode?  The only way I have accomplished this is by leaving the program or
> loading a different data base.
>
> _______________________________________________
> Loadstone mailing list
> Loadstone at loadstone-gps.com
> http://www.loadstone-gps.com/mailman/listinfo/loadstone
>


More information about the Loadstone mailing list