[Loadstone] Dry run without RX

Shawn Kirkpatrick shawn at odyssey.cm.nu
Fri Aug 25 09:58:03 BST 2006

The most likely explanation is you have the wrong coordinate values. Without 
knowing where you are it's hard to say. The latitude and longitude could 
also be reversed. When you get a receiver you'll know for sure.

On Fri, 25 Aug 2006, Rob Melchers wrote:

> Hi all,
> I've just started using Loadstone and while waiting for my receiver to arrive 
> I tried to play around with the software. I labeled my celltower and entered 
> two POI's that I retrieved from a local website. Named them 'a' and 'b', 
> entered latt and long in decimal, saved the data and exported it to my PC. 
> Here's the content of the file:
> (see below)
> In navigation mode I hear the expected 'not connected', but in exploration 
> mode I just hear 'No Points Mount'. I figured, that with this small database 
> I should be able to explore a walk from 'a' to 'b'. Selecting 'Find Point' 
> does no good. What am I doing wrong?
> Rob
> table,point name,latitude,longitude,accuracy,satellites,priority,userid,id
> "a",523521000,49763000,1,0,0,39670,1156476665
> "b",523508000,49775000,1,0,0,39670,1156476949
> table,cell
> id,mcc,mnc,locationareacode,cellid,userid,name
> 1156321913,204,20,10304,17711,39670,"diemen noord"

More information about the Loadstone mailing list